View Single Post
Old August 25, 2012, 02:55 PM   #4
math teacher
Senior Member
 
Join Date: February 5, 2012
Location: Southwest WA Coast
Posts: 314
Herters and some other companies used to make shell holders for some of their presses that did not interchange. Most all do now. However they may vary a little in dimensions, so the dies need to be set for the shell holder in use. As I use one press for sizing and another for priming and bullet seating, I have two of each size, often of different makes. I would not want to leave a die in a press and just slip in a shell holder without checking for proper adjustment. I can't picture doing this, but it makes the point.
math teacher is offline  
 
Page generated in 0.04215 seconds with 7 queries