View Single Post
Old August 25, 2012, 01:19 AM   #1
JHansenAK47
Senior Member
 
Join Date: May 25, 2011
Posts: 185
SIG roll pin installation

I have a police trade in P228 that I recently detail stripped, cleaned up, replaced the springs and installed an SRT trigger and during the course of that I messed the roll pin up while installing it in the sheet metal slide. Lesson learned I ordered some roll pin punches to install it correctly.

Which brings me to my question. What is the order for installing the double roll pins into the slide?

I was thinking that you put in the outer roll pin in the slide/breech block from left to right then installed the inner roll pin with the open seam facing 180 degrees from the other roll pin.

Is that correct? Or am I going to mess up my inner roll pin or just doing it the hard way?
__________________
Practical before tactical.
JHansenAK47 is offline  
 
Page generated in 0.05246 seconds with 7 queries