View Single Post
Old August 23, 2012, 04:54 PM   #14
Powderman
Senior Member
 
Join Date: September 7, 2001
Location: Washington State
Posts: 2,160
When I'm loading BPCR cartridges, I'll first dump the powder into the case through a long drop tube. Then, the overpowder wad is pressed into the mouth of the case, and seated by the compression die. Next, the grease cookie (for paper patched bullets) is placed, followed by a lube sealer wad (same as the overpowder wad, just that it's next to the grease cookie).

To prevent it from sticking to the bullet, I'll have an alcohol cloth. The bullet base is wiped across it, then onto a dry cloth, then it's seated into the case.
__________________
Hiding in plain sight...
Powderman is offline  
 
Page generated in 0.04931 seconds with 7 queries