View Single Post
Old August 21, 2012, 07:30 PM   #5
ssblair
Member
 
Join Date: April 29, 2010
Location: Indiana
Posts: 21
So if I understand things correctly, the concern is about the heat treating of the bolt lugs still being proper? And wyop--could you cite your source for the case hardness being 54-60 Rc?

I'm familiar with steel fabrication and heat treat specs, and I hesitate to believe that simply spot welding the face of the bolt would have such a wide heat affected zone as to temper the locking lugs--But it's easy enough to check.

Thanks!
ssblair is offline  
 
Page generated in 0.04152 seconds with 7 queries