View Single Post
Old August 19, 2012, 04:57 PM   #39
wncchester
Senior Member
 
Join Date: December 1, 2002
Posts: 2,830
"However, if it is also out of level in the X axis, it causes drag on parts of the scale that should not be touching."

It's important that the X axis (Z actually) be at least close to level but 'eye ball' level is plenty good enough. It's obviously important that the beam's axle be centered fore and aft so one end won't rub on a bearing retainer clip but that's simple enough to keep visual track of.
wncchester is offline  
 
Page generated in 0.05081 seconds with 7 queries