View Single Post
Old August 18, 2012, 07:17 PM   #10
LOUD
Senior Member
 
Join Date: May 29, 2010
Location: Virginia
Posts: 235
well I did something , I made a annealing jig . I took a 2 inch section of one inch diameter bolt and ground it to a point and then found a way to suspend it and not have to try holding it till it cooled . then I took my oxy/acet rig and heated the pointed bolt to a bright red color and let it down on the reciever till cool to the touch . The only point of contact was the three dimples my first attempts created and the red hot end of the bolt. i then drilled and the tapped the holes perfectly , I am thrilled to get this phase of the project finnished.anneal 2.jpg

anneal 4.jpg
LOUD is offline  
 
Page generated in 0.04638 seconds with 8 queries