View Single Post
Old August 9, 2012, 01:12 PM   #1
jclayto
Senior Member
 
Join Date: February 14, 2005
Location: Anderson, SC
Posts: 539
Old Mec 600jr question - charge bar

I picked up a old used 600 jr recently but it did not come with a charge bar. I ordered the charge bar and powder bushing but realized after it arrived that I do not have the hex screw that goes into the powder bar to stop it as it slides from side to side.

Does anyone know what size / thread type this should be? I am going to go to my local hardware store and pick one up tonight but don't have the bar with me to size it up.
jclayto is offline  
 
Page generated in 0.05244 seconds with 7 queries