Thread: Sight question
View Single Post
Old August 7, 2012, 08:55 PM   #2
Creeper
Senior Member
 
Join Date: September 9, 2008
Location: Woooooshington
Posts: 1,797
Quote:
It appears the material used to hold the sight in to milled cut didn't hold.
By this do you mean a piece of shim stock they used to tighten up the fit?

Get some more and/or thicker shim stock to tighten the sight to slide "wedge". You don't really want to Loc-Tite the rear sight... you might need to adjust it it some day.

Cheers,
C
__________________
Shoulder Drive Nicholson Club
Creeper is offline  
 
Page generated in 0.04888 seconds with 7 queries