Thread: Sight question
View Single Post
Old August 7, 2012, 08:11 PM   #1
carprivershooter
Senior Member
 
Join Date: February 16, 2008
Location: Michigan, Upper Pennsula
Posts: 396
Sight question

The rear sight on my Springfield Armory 1911 loaded came lose. It appears the material used to hold the sight in to milled cut didn't hold. I don't want to send it back to springfield unless it is really necessary. I have some medium duty locktight so I could use it to remount to sight. These are Knovak sights. I am thinking I would put the locktight on the leading edge of cut and at the mid point anf then slide the sight into the cut and then attemp to re- alinethe sights. then clean up any goo the finds it way out of the cracks. Does this sound like a plan? I want to get in right the first time and not have to beat the crap out of the sight after it's in place.
__________________
CarpriverShOOter
Finch, I don't like guns. Reese, Me either but if someone has to have guns I'd rather it be me. (Person of Interest).
No trees were destroyed in the posting of the this message
carprivershooter is offline  
 
Page generated in 0.06672 seconds with 7 queries