View Single Post
Old August 6, 2012, 11:50 AM   #52
browninghunter86
Senior Member
 
Join Date: November 14, 2011
Posts: 524
interesting that 2825 was calculated. that is what JBM velocity is to get 1.5" high at 200 and the 2.5" high at 100yards ***Sorry mis-posted it earlier stating it was 2.5" at both 100 and 200 yards***

But that pressure is extremely high isn't it? SAAMI is 62,000PSI correct?

But I did not see any pressure signs with the loads though...... No flatened primer, no hard bolt lift, pressure ring measured same as factory ammo brass
browninghunter86 is offline  
 
Page generated in 0.04377 seconds with 7 queries