View Single Post
Old August 3, 2012, 10:10 PM   #1
M4BGRINGO
Senior Member
 
Join Date: March 22, 2011
Posts: 241
Single Action Question

New to single action revolvers, here's my question: Does the ejector rod normally run along the edge of the cylinder, or should it run down the center of the cylinder, to eject the brass?

Mine was hitting the cylinder on most of the chambers, would only go down a few. I have no idea why it isn't simply centered in each chamber, then it wouldn't hit anything.
M4BGRINGO is offline  
 
Page generated in 0.04252 seconds with 7 queries