View Single Post
Old August 3, 2012, 07:53 PM   #6
William T. Watts
Senior Member
 
Join Date: January 20, 2010
Location: Central Arkansas
Posts: 758
I would pull the bullet (if you don't have a puller use pliers) dump the powder and punch the primer out. You should determine why you failed to seat the primer, obviously you did not do a visual or you would have seen it not seated properly. Always check the primer is seater at least flush or slightly below. William

Last edited by William T. Watts; August 4, 2012 at 09:41 PM.
William T. Watts is offline  
 
Page generated in 0.04344 seconds with 7 queries