View Single Post
Old August 3, 2012, 07:49 PM   #5
Jeff H
Senior Member
 
Join Date: August 20, 2009
Posts: 148
If you have a kinetic puller, you'll notice that the shell holder is about the same size as the collet. Tape it on if you can't get the threaded nut on over the shell holder. Put the whole thing in and pull the bullet then seat the primer deeper once there is no more powder and bullet.

I have reseated a few primers in loaded rounds before, but I always feel pretty nervous doing it. Although I've never set off a primer seating it, you never know.....

Last edited by Jeff H; August 3, 2012 at 08:01 PM.
Jeff H is offline  
 
Page generated in 0.05121 seconds with 7 queries