View Single Post
Old July 30, 2012, 04:33 PM   #1
Dangerwing
Senior Member
 
Join Date: April 9, 2007
Location: South Dakota
Posts: 237
hi point 9mm carbine sling stud

Im looking for some technical advise. I recently bought a used Hi Point model 995 9mm carbine. It shoots surprisingly well and over all I'm very happy with it. There is one glitch though - the rear sling stud is mounted on the right side of the stock. This would be great if I was left handed, but I'm not. I disassembled the stock (splits in half along the length of the stock), but I can't figure out how to removed the threaded nut that is in the stock so I can move it to the other side. Is it just press fit in there? Is it removeable? Any help would be appreciated.

Thanks
__________________
Alcohol Tobacco and Firearms should be an aisle at Wal-Mart, not a government agency!

Only faithful men teach their wives to shoot.
Dangerwing is offline  
 
Page generated in 0.05398 seconds with 7 queries