View Single Post
Old July 29, 2012, 10:55 AM   #1
Beagle333
Senior Member
 
Join Date: January 7, 2012
Location: Auburn, AL.
Posts: 1,365
The "Turtle Buster"

I'm pretty excited about this new addition. This was a 358432 160gr mold that I had HP'd to make an awesome 137gr HP for just plinking cans or paper or turtles (if you got a problem with em ) I just got it back from getting the pins in it, so I haven't gotten to load any of em yet, but this looks really promising. The flat pin is so I can cast the original wadcutter as well.
I'll post some more info on performance after I get a chance to test it out, but I'm pretty excited to just have it.
Beagle333 is offline  
 
Page generated in 0.04622 seconds with 7 queries