View Single Post
Old July 22, 2012, 11:32 PM   #3
Creeper
Senior Member
 
Join Date: September 9, 2008
Location: Woooooshington
Posts: 1,797
Almost forgot... when you get to this bit in the instructions:

Quote:
Originally Posted by Novak instructions
"*IMPORTANT* Before marking holes, check it insure rail is aligned with the trigger guard and the rail is not canted side to side. Some dust covers are not a perfectly radius, so visually verify that the rail is level side to side."
I get my best alignment by checking everything with a machinists square, a spirit level and a hole centering punch.

That is all,
C
__________________
Shoulder Drive Nicholson Club
Creeper is offline  
 
Page generated in 0.04579 seconds with 7 queries