Thread: Seating XTPs
View Single Post
Old July 22, 2012, 10:19 PM   #1
farmerboy
Junior member
 
Join Date: May 16, 2009
Location: Central Texas
Posts: 1,343
Seating XTPs

When seating XTPs on a Rockchucker press do you guys have better luck with the flat seating plug or the concave. Am loading 357 Sigs not that I think it would matter much if it were 357 Sigs or 357 or 40s. But just talking to someone who asked which should make more accurate lengths and not close the hollow points at all. Using RCBS Dies.

Last edited by farmerboy; July 22, 2012 at 10:56 PM.
farmerboy is offline  
 
Page generated in 0.05298 seconds with 7 queries