Thread: rusting dies
View Single Post
Old July 21, 2012, 10:46 PM   #6
tkglazie
Senior Member
 
Join Date: December 3, 2011
Posts: 558
I was not aware that this was a problem. So far I have not seen any rust but I will keep an eye out. I typically use break-free CLP on my dies and press equipment.

I needed a good excuse to give my dies a good cleaning anyway. The range isnt open until 1 tomorrow, might as well spend the morning cleaning the oiling dies.
tkglazie is offline  
 
Page generated in 0.04595 seconds with 7 queries