Thread: New Miha mold
View Single Post
Old July 12, 2012, 11:30 AM   #17
saltydog452
Senior Member
 
Join Date: August 16, 2004
Posts: 487
Snuffy, post # 12

The lube, synthetic 2 cycle oil, does not wick to the face/cavity or cook off the pins and plate?...if so, does it need to be reapplied occasionally?

I ask because I have apparently just plain, flat ruined a H&G and do not want to repeat that same mistake.

I got out of casting for a bunch of years and slathered a bunce of wheel bearing cup grease on the H&G before putting it in the closet. Its never been the same since.

Convoluted logic directed me to Miha and his no oxide blocks. Now I understand that they need lube to 'run'?

Suggestions appreciated.

thanks,

salty
saltydog452 is offline  
 
Page generated in 0.04133 seconds with 7 queries