Thread: New Miha mold
View Single Post
Old July 12, 2012, 10:05 AM   #16
Stick_man
Senior Member
 
Join Date: October 18, 2008
Location: Salt Lake City, Utah
Posts: 241
On my 402-160 mold, I found that adding about 1% tin to my 50/50 COWW/SOWW alloy and then running at about 720* will give me excellent results with a reject rate well below 10%. The mold does like to run hot, generally bordering on frosting the boolits. The 359640 is showing signs it likes things the same as the 402-160. Both molds are 2-cav but I have just started to cast with the 359640. There is a little bit of a learning curve with each mold but once you get them running they don't want to stop.
Stick_man is offline  
 
Page generated in 0.04717 seconds with 7 queries