Thread: New Miha mold
View Single Post
Old July 10, 2012, 05:53 PM   #9
FrankenMauser
Senior Member
 
Join Date: August 25, 2008
Location: 1B ID
Posts: 6,843
The sprue plate adjustment is handled by a hex-drive screw with a spring washer under it (serving as the hinge pin). It is locked in position by a hex-drive set screw found on the side of the mold block.
-The allen wrenches shown in the photos on the MP website come with each mold, and are for that very purpose.

I don't know anyone that has had to adjust alignment pins in a Miha mold. But if it was needed, they just use an interference fit.
__________________
"Such is the strange way that man works -- first he virtually destroys a species and then does everything in his power to restore it."
FrankenMauser is offline  
 
Page generated in 0.04293 seconds with 7 queries