View Single Post
Old July 8, 2012, 10:41 AM   #39
Senior Member
Join Date: February 7, 2009
Location: Southern Oregon!
Posts: 1,505
I would suggest (and mebbe I'm alone in this) that you consider learning safe reloading habits/methods rather than choose components by "if I make a mistake". Use the powder that best suits your intended purpose with the bullet of your choice, and learn how to reload it safely.

I check every powder charge in every case I reload. I visually inspect every case before I seat a bullet. And there are other "tricks" to safe powder charging; my sized/primed cases are sitting in one reloading block on the bench and as each one is charged, it is set in another reloading block. Then before I seat the bulets I pick up the block and either use a Mini-Maglight or bright desk lamp, look in every case. There's a bunch of methods/quirks to making sure only one powder charge gets in each case, an I'm sure some will be added (flip-flop cases, powder check dies, etc.)...
My Anchor is holding fast!
I've learned how to stand on my own two knees...
mikld is online now  
Page generated in 0.05464 seconds with 7 queries