View Single Post
Old July 5, 2012, 04:53 PM   #17
m&p45acp10+1
Senior Member
 
Join Date: May 3, 2009
Location: Central Texas
Posts: 3,307
I just use a water bottle with the squirt cap. Pull the bolt. Point the barrel at the ground. Turn the water bottle, insert it into the breach area. Squirt some water in. Wait a couple of seconds and repeat. Then I run a water soaked patch down the barrel. Then give it a few minutes to dry out some. Run dry patches till they come out dry. Follow with a lightly oiled patch. Then finish with running a dry patch to remove the excess oil. Wipe the bolt with some oil, and remove the excess. Reassemble then call it done.

Total time is about 10 minutes. If I am brushing to remove copper fouling then add another 15 to 30 minutes.
__________________
No matter how many times you do it and nothing happens it only takes something going wrong one time to kill you.
m&p45acp10+1 is offline  
 
Page generated in 0.04371 seconds with 7 queries