View Single Post
Old July 4, 2012, 05:44 PM   #9
mehavey
Senior Member
 
Join Date: June 17, 2010
Location: Virginia
Posts: 3,053
Big assumption: You are full length resizing. Die mouth solidly in contact with the shell holder at full stroke.

First: If all resized (but empty) cases load and extract OK, you do not have a resizing problem.

Second: if any loaded cases then fail to extract before firing, you have either a bullet length
problem (unlikely) or a crimping problem that's deforming the case shoulder. (more likely)
Solution: Do not (repeat, NOT) crimp at all....back that seating die at least one full turn
away from any contact with the empty case mouth... then try those rounds for function.

Third: If rounds will chamber/extract OK before firing, but then stick/fail to extract upon firing, we'll go to the next step....
mehavey is offline  
 
Page generated in 0.04366 seconds with 7 queries