View Single Post
Old July 3, 2012, 01:29 PM   #1
ScottRiqui
Senior Member
 
Join Date: January 27, 2010
Location: Norfolk, VA
Posts: 2,905
How to thread semi-auto barrel for a suppressor?

I know the preferable method is to find a barrel that sticks out past the end of the slide, and cut threads into the outer surface of the barrel, but for pistols where the aftermarket selection is non-existent, is it acceptable to drill out the last 3/4" or so of the barrel and thread the inside of the newly-cut surface to accept the adapter?
ScottRiqui is offline  
 
Page generated in 0.03484 seconds with 7 queries