View Single Post
Old June 30, 2012, 04:24 PM   #2
Fleet
Senior Member
 
Join Date: December 1, 2011
Posts: 108
The threads in this action aren't metric. I had this problem come in earlier this year. I believe I used a 1/4-20 tap (the receiver is threaded 20 threads per inch) to act as a thread comb. It takes a while, and a bit of effort, but you can clean it up that way. Just put the tap in the receiver, and start scraping back and forth around the inside of the action. It'll smooth out.
Fleet is offline  
 
Page generated in 0.05232 seconds with 7 queries