View Single Post
Old June 24, 2012, 07:33 PM   #6
saands
Senior Member
 
Join Date: November 14, 1999
Posts: 1,551
Can I? You be the judge, here's the data.



I'd argue that, with a micrometer in hand (and not a caliper or a ruler) anyone should be able to ... after all, micrometers typically give you 0.0001" or 0.00005" resolution. Then, if you take multiple readings on each sample (I took 6 readings on each of 9 bullets) any noise that might be in the measurement system goes down.

By the way, while it may be true that the 0.0004" is within the tolerances for most makers, that tolerance is probably lot to lot variation ... and for the sloppy ones it might be bullet to bullet variation, but I have NEVER seed that kind of variation within a single bullet.
Attached Images
File Type: jpg OS 220gr.jpg (179.0 KB, 146 views)
saands is offline  
 
Page generated in 0.05463 seconds with 8 queries