View Single Post
Old June 22, 2012, 01:29 PM   #5
doofus47
Senior Member
 
Join Date: June 9, 2010
Location: live in a in a house when i'm not in a tent
Posts: 1,278
My suggestion from experience.

I filled an old contact lens saline bottle with 1/2 ammonia and 1/2 water. After shooting, while the barrel was still hot, I would put a patch wet (but not sopping, dripping wet) of this solution down the barrel and rub off the bolt/chamber. I then ran a dry patch to pick up the water/salts.
Any residual water dried fast b/c of the barrel heat. I then went home and and cleaned as I would regularly using Hoppe's 9. I never had a problem with rust or corrosion or de-laminated stocks.

About 3 mins extra time all told.
doofus47 is offline  
 
Page generated in 0.04662 seconds with 7 queries