View Single Post
Old June 19, 2012, 09:49 PM   #8
res45
Senior Member
 
Join Date: September 15, 2007
Posts: 553
Ed Harris told me to just coat the iron molds in USP Mineral Oil it prevents rust and burns off cleanly when you heat the mold on your hot plate with no cleaning before or after necessary. I've been doing this for several years now with my two old Ideal/Lyman molds.

After the mold cools I brush a coat of USP Mineral Oil over the entire mold block and sprue plate,rubber band the two halves together and put them in a zip lock bag and store them in an old coffee can.
res45 is offline  
 
Page generated in 0.05339 seconds with 7 queries