View Single Post
Old June 19, 2012, 09:47 PM   #7
Ideal Tool
Junior member
 
Join Date: October 6, 2010
Location: Michigan
Posts: 1,080
Hello, awbrock. Since there is a chance I might not use that particular mould again for awhile..after casting, while mould is still hot, I clean off all lead deposits, etc. Then while still warm..being able to hand hold metal parts.. I spray with an industrial product called Mold Saver..has lanolin in it..I like to keep halves open to allow product to dry overnight..I know they will be just as I last used them. Clean up for re-use is simple using brake cleaner & a hot soapy water bath..lately I have been just using the hot soapy water.
Ideal Tool is offline  
 
Page generated in 0.04758 seconds with 7 queries