View Single Post
Old June 19, 2012, 11:19 AM   #1
Doug Bowser
Senior Member
 
Join Date: May 6, 2005
Posts: 161
Trouble with C&B Dragoon

I have a Replica Arms 2nd Model Dragoon by Uberti. It functions well until the trigger is pulled. Then the cylinder lock jumps out of the cylinder lock notches and the cylinder turns slighly before the hammer hits the ege of the notch cut out for the nipples. I bought a new cylinder stop and it does not fit. Should I check how much the bolt stop sticks above the frame? I have replaced a broken sear spring and I have the bolt stop part of the spring exerting a lot of pressure on the bolt stop. What would be my next step? Can I safely grind off the top of the bolt stop leg and allow the bolt stop to rise higher out of the frame?

Doug
Doug Bowser is offline  
 
Page generated in 0.04902 seconds with 7 queries