View Single Post
Old June 14, 2012, 02:56 PM   #5
CS86
Senior Member
 
Join Date: February 28, 2012
Location: South Dakota
Posts: 220
Check that your sizing die is far enough down. I have the hornady LNL AP when I first started loading 9mm, I thought the die was all the way down, but it wasn't. I ended up with the same problem. I ended up pulling the bullets and resizing. I was scared that if the bullet was forced into the casing further from driving up the feed ramp of the gun, that it would cause excessive pressure.
CS86 is offline  
 
Page generated in 0.04087 seconds with 7 queries