View Single Post
Old June 9, 2012, 09:42 AM   #11
tpcollins
Senior Member
 
Join Date: February 18, 2009
Location: SE Michigan
Posts: 443
I started with boat tails on .204 and .243 but some of the "chamfers" range from .060" up to .100" wide and is a bit tough sometimes to get a full caliber length of contact in the neck. I use a VLD tool and put a chamfer on the inside of the neck and the flat base bullet sits there good enough to get up inside the bullet seater.
__________________
What direction did that last shot at Kennedy come from?
tpcollins is offline  
 
Page generated in 0.04925 seconds with 7 queries