View Single Post
Old May 31, 2012, 02:53 AM   #11
Mike / Tx
Senior Member
 
Join Date: April 8, 2000
Posts: 1,316
Just guessing here, but the OP is more than likely talking about the 124gr RN with the TL rings verses the standard lube grooves.

If so, and it were me, I would put just enough of a tapered crimp to close up the mouth of the case and provide reliable feeding, to to prevent set back. Maybe seat them to just under the top ring and lightly crimp under it so as to have a stop that prevents set back during the chambering of a round or possibly while in the clip.
__________________
LAter,
Mike / TX
Mike / Tx is offline  
 
Page generated in 0.04250 seconds with 7 queries