View Single Post
Old May 30, 2012, 11:56 AM   #1
deerhunter13
Junior Member
 
Join Date: May 30, 2012
Posts: 4
hand loads for a 30-06, 308, 22-250 rifles

[B]Hello my name is Dan and I have a couple of question and I was wondering if anyone could give me some answers. I hand load for 3 calibers 30-06, 308, 22-250. Lately I been getting a stuck bolt in some of my loads after the shot. A friend suggested that I should full length size my brass instead of always neck size them, even if its for the same rifle. Is there any truth to this? Also I am having some concentricity problems with run offs of 5-7 thousand would it help if I get completion dies for my Dillon 550 press? And would I need both dies or just the seating die?[/B]
deerhunter13 is offline  
 
Page generated in 0.04551 seconds with 7 queries