View Single Post
Old May 26, 2012, 06:04 PM   #1
123kiwi
Member
 
Join Date: March 23, 2006
Location: New Zealand
Posts: 65
77/22 Light Firing Pin Strike (.22)

I got a good deal on a rifle sans bolt but had a spare bolt at home so all good. Took it out to put a couple through it but found it was only putting a slight dent in the rim of the case.
Half cycle the bolt a couple of times and it would eventually fire but then not fire the next round.
Interestingly, if I put a spent case into the breech and fired, it would come out with a good looking indentation on it.
Have stripped and cleaned the (brand new) bolt and also taken apart and cleaned up the fire control bits.
Does anyone have any ideas on the cause or possible solution to this problem?
I did notice a gap of 0.014 between the bolt and back of the barrel which closes up after trigger is pulled, is this normal?
I'm hoping some knowledgeable member may have seen this before?? Cheers!
123kiwi is offline  
 
Page generated in 0.04052 seconds with 7 queries