View Single Post
Old May 25, 2012, 06:16 AM   #4
mykeal
Senior Member
 
Join Date: October 8, 2006
Location: Northern Michigan
Posts: 2,758
The trigger sear is catching on the half-cock notch, which it should do with the hammer moving slowly and no finger load on the trigger.

I don't understand this part:
Quote:
the point where the bolt gets unlocked
When lowering the hammer after being in full cock there is no point where the bolt "gets unlocked". The bolt should stay up in the cylinder stop notch for the full hammer throw all the way down to the frame.
mykeal is offline  
 
Page generated in 0.04160 seconds with 7 queries