View Single Post
Old May 21, 2012, 10:52 PM   #5
F. Guffey
Senior Member
 
Join Date: July 18, 2008
Posts: 2,768
“I recently had a local 'smith assemble a rifle for me with my chosen parts. The action is an FN SPR, the barrel a Shilen match grade stainless select blank which he turned and chambered in .308 for me”

Had I cut your chamber I would thought the length of the chamber important enough I would have informed you the length of the chamber from the bolt face to the shoulder of the chamber, and I would have instructed you on sizing cases to fit by adjusting the die to prevent moving the shoulder back too far, and I would have formed one case you could use to check your gages with.

F. Guffey
F. Guffey is offline  
 
Page generated in 0.04565 seconds with 7 queries