View Single Post
Old May 20, 2012, 06:19 PM   #1
jimisbell
Member
 
Join Date: May 19, 2012
Location: Third Coast
Posts: 24
Stevens 820B problem?

I am repairing a Stevens 820B 12Ga. One of its several problems was the Slide Lock Spring, which had broken. I got the small piece that was hooked behind the pin out by grabbing it with pliers and bending it out. But putting the new one in presents another problem. I cant see how to get it back in without bending it and I dont want to bend a new spring. Is there a trick to getting the new slide lock spring installed?
__________________
If you are NOT living on the edge, well then, you are just taking up too much space.
jimisbell is offline  
 
Page generated in 0.04864 seconds with 7 queries