View Single Post
Old May 20, 2012, 03:23 PM   #2
Kadmos
Member
 
Join Date: April 27, 2010
Posts: 93
With the grip removed there is a very small flush screw on the frame by the left side grip screw, This must be removed. First the hammer and hand must be installed, then the pin drops into the hole, then a tiny spring, then the screw replaced.

I have a bad feeling the spring may have launched somewhere across the room when you pulled the hammer/hand.

In the future take the little screw out first, do not pull the hammer out without pulling the hand spring and pin out first.
Kadmos is offline  
 
Page generated in 0.04288 seconds with 7 queries