View Single Post
Old May 19, 2012, 11:37 AM   #1
jimisbell
Member
 
Join Date: May 19, 2012
Location: Third Coast
Posts: 24
Slightly undersized AK-47 barrel

I have two AK-47 barrels that are about .008" too small to make a press fit to the front trunions. I am planing on using a knurling tool on my lathe to slightly expand the barrel to fit the trunion.

Are there other options?
__________________
If you are NOT living on the edge, well then, you are just taking up too much space.

Last edited by jimisbell; May 19, 2012 at 01:00 PM.
jimisbell is offline  
 
Page generated in 0.05786 seconds with 7 queries