Thread: bullet puller ?
View Single Post
Old May 11, 2012, 01:00 AM   #7
jimkim
Senior Member
 
Join Date: July 3, 2008
Location: middle GA
Posts: 319
Lee FCD body and a multitool or needlenose pliers. Remove the collet from the FCD body. Place the round in the shellholder and raise it. Lightly squeeze the pliers on the bullet being careful to avoid the neck. Lower the ram. The pliers will self-tighten and pull the bullet. This only works if there is sufficient bearing area for the pliers to grip. If the bullets have a heavy crimp you should loosen them first with a seating die. Just bump it enough to break the crimp. The smaller the contact area the fewer the marks on the bullet.


__________________
Jan. 4, 2007 gasoline $2.10 gal....HMMM?
jimkim is offline  
 
Page generated in 0.05446 seconds with 7 queries