Thread: Stuck wedge?
View Single Post
Old April 30, 2012, 12:27 PM   #26
TomADC
Senior Member
 
Join Date: October 14, 2009
Posts: 546
Okay its apart and looks fine.
BUT you ask how did you do it? Why he found the perfect cheap wedge tool. Went to Home Depot and bought a solid brass surface bolt made by Everbilt # 308972 I pulled the handle off the sliding part and used the inner bar, saw off the screw hole on one end (this is the part that screws to the wall) I found it fits the wedge slot perfectly a couple of taps with a small brass hammer the the wedge moved enough to remove with my fingers.
Did show signs of being driven in.

You can see the part I used here.
http://www.homedepot.com/h_d1/N-5yc1...&storeId=10051
__________________
US Navy Retired,NRA Life Member,SASS member, Time magazine's Person of the Year 2006!

Last edited by TomADC; April 30, 2012 at 04:24 PM.
TomADC is offline  
 
Page generated in 0.04303 seconds with 7 queries