View Single Post
Old April 29, 2012, 09:31 PM   #17
BerdanSS
Senior Member
 
Join Date: April 3, 2011
Location: to close to other houses
Posts: 930
Sorry for the size and quality of the picture.....it's the best I can do right now. Oh and for kicks I just looked up the codes, it was manufactured in 2001

Oh and Hawg, FYI it is penned on both sides of the notch, the lead side pretty deep and the other just barely noticeable...If that helps...not sure if it does

Going to take the bolt out tomorrow after work and check it manually as you suggested.....but the digital calipers haven't lied to me yet so I expect it will fit. Could the bolt being too small cause the same problem?

Last edited by BerdanSS; April 29, 2012 at 09:41 PM.
BerdanSS is offline  
 
Page generated in 0.04302 seconds with 7 queries