View Single Post
Old April 29, 2012, 07:57 PM   #2
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,568
I would remove the forend wood & apply mild heat to the outer mag tug at the same time the inner tube is being pulled out from it.

If the inner tube isn't gunked up, a shot of sanding with fine emory paper should slick up the brass.

Don't forget, as many do, to also clean/scrub the inside of the outer tube.

.
PetahW is offline  
 
Page generated in 0.04762 seconds with 7 queries