Thread: Caliber Change
View Single Post
Old April 17, 2012, 09:13 AM   #5
WESHOOT2
Senior Member
 
Join Date: February 20, 1999
Location: home on the range; Vermont (Caspian country)
Posts: 14,242
Quote:
I load on a Dillon 650 - with a case feeder....so volue is easily 800 - 1,000 rds an hour ( if all you're doing is cycling the handle).

Changing over calibers...15 min or so ( its not a speed drill ) --- I clean up the press, lube everything, clean the dies I'm removing for next time..clean the case feeder plate..wipe out the case feeder, etc.../ but it just takes a few minutes. I have tool heads setup for every caliber I load ...with a powder measure and a powder check die adjusted and installed ...so unless I change bullets or powder or something ...change over is real easy.

If I go from large to small pistol primers...I change the primer system too ...and take it apart and clean it as well ...for next time. But that only adds 5 min at the most...( take one off - and clean it - and put the other one on the press ).
Ditto.
__________________
.
"all my ammo is mostly retired factory ammo"
WESHOOT2 is offline  
 
Page generated in 0.04161 seconds with 7 queries