View Single Post
Old April 16, 2012, 10:43 PM   #5
Misssissippi Dave
Senior Member
 
Join Date: December 5, 2009
Posts: 1,381
I don't load to max levels and I will use CCI, Winchester, Remington and Federal primers as one in the same. I only do this with pistol loads that are not at or near max. levels. I would need to run them past a chrony to tell the difference if there is any. The biggest differences I have seen are how well the feed in the primer tube and how hard the primers are for pistols with lightened hammer springs. The order I have found from hardest to softest is CCI, Remington, Winchester and Federal being the softest.
Misssissippi Dave is offline  
 
Page generated in 0.04276 seconds with 7 queries