View Single Post
Old April 16, 2012, 07:36 PM   #2
Semper Paratus
Senior Member
 
Join Date: May 21, 2004
Location: Tidewater, VA
Posts: 141
Take the primer feed assembly loose by removing the two screws from the underside and clean all of the running surfaces with alcohol or similar. After that many rounds may take a little persuasion for all the gook and foreign material to go away and then lube with one of the dry lubes (teflon or powdered graphite) reassemble and try with a few primers....If better your done....if not call Dillon they will walk you through solving any problem and if necessary send you the replacement parts.
__________________
Semper Paratus--Always Prepared
Semper Paratus is offline  
 
Page generated in 0.04931 seconds with 7 queries