View Single Post
Old April 15, 2012, 09:44 PM   #11
geetarman
Senior Member
 
Join Date: November 18, 2009
Location: Arizona
Posts: 2,745
With that out of the way, I would guess extractor tension.

My SR1911 had similar issues and that was the diagnosis. The gunsmith onsite at my range fixed in about 6 minutes and did not charge me a dime.

I had the slide off the gun when I took it in and he popped the extractor out and bent it a little. The gun has run like a champ since then. I hope you have good luck. My feel is I would let a local smith look at it before I went through the trouble sending it back.

Geetarman
geetarman is offline  
 
Page generated in 0.04019 seconds with 7 queries