View Single Post
Old April 4, 2012, 06:51 AM   #3
tango1niner
Senior Member
 
Join Date: March 5, 2009
Location: rural upstate NY
Posts: 118
Is the primer flattened and flowing into the pit? If yes it sounds as if you have a pressure problem. If the primer is backing out of the pocket but not flattened you may have loose primer pockets or worse yet a headspace issue. A worn firing pin hole can be bushed. I would not weld on a bolt face/head as you could/would change the heat treatment qualities of said part.
tango1niner is offline  
 
Page generated in 0.04642 seconds with 7 queries